With the issue that I have with my 308 brass some being really short, I was thinking about pulling all the 308 that I have loaded and check the case length. I must have close 600 - 700 rounds loaded. If I do, I think that I am going to do it by powder that is loaded. I really like Varget and have some on hand. I know that you are not suppose to mix lots of the same powder but for what I am doing and with what I am shooting them out of I do not think it would matter. Will not start the ladder reloading test until the new dies comes in on Monday or Tuesday.
Also. I am using a RCBS collet bullet puller and when I run the pulled cases through the resizing die, would you take out the depriming pin. I do not see any reason to deprime them.
Also. I am using a RCBS collet bullet puller and when I run the pulled cases through the resizing die, would you take out the depriming pin. I do not see any reason to deprime them.