RacerX
Professional Knucklehead; aka Jeffncs / RacerX
2A Bourbon Hound OG
Charter Member
Supporting Member
I used a drilling rod from McMaster Car to check barrel-muzzle device-suppressor straightness... assuming the rod is straight, is this a safe alignment?
As you’ll see on the picture, the rod favors one side but it’s a clean pass through the suppressor with no touching at all. When I spin the rod from the breach end while it’s in place, the tight spot remains in the same spot on the suppressor giving some level of assurance that the rod is straight.
As you’ll see on the picture, the rod favors one side but it’s a clean pass through the suppressor with no touching at all. When I spin the rod from the breach end while it’s in place, the tight spot remains in the same spot on the suppressor giving some level of assurance that the rod is straight.