Anyone do 3D printing?

Njdevil

WPP transplant
Joined
Dec 19, 2016
Messages
169
Location
Eastern SC Outside of Florence
Rating - 100%
2   0   0
I need a cover made for my boat gps they are discontinued and I have searched the web with no luck

I do have a old one I can send for a template

let me know if you can help
pics of unit
 

Attachments

  • IMG_3762[1].JPG
    IMG_3762[1].JPG
    136.2 KB · Views: 17
  • IMG_3757[1].JPG
    IMG_3757[1].JPG
    190.4 KB · Views: 17
Last edited:
There's others that are better since it's going to be exposed to UV and temperature swings.

What material are you using now?

PLA is what I have to got work on my setup. I tried to set mine up to run ABS, and it never stuck even after trying hairspray, painters tape, etc.

Never really messed with anything else but PLA, and ABS. Really only mess with PLA as my machine is setup to do what I need it to do without much fuss.

Plus not bad for $100 investment
 
PLA is what I have to got work on my setup. I tried to set mine up to run ABS, and it never stuck even after trying hairspray, painters tape, etc.

Never really messed with anything else but PLA, and ABS. Really only mess with PLA as my machine is setup to do what I need it to do without much fuss.

Plus not bad for $100 investment
I assume you have a heated plate?

If so clean it (soap and water, dry it off) Run Elmer purple glue over the top (lightly). Heat it up for 10-15 minutes ABS will stick if you have your offsets correct. If you don't have a enclosure you are fighting a uphill battle. I'm the opposite, use ABS, Nylon and a few others.
 
Back
Top Bottom