wired Well-Known Member Vendor Joined Jul 9, 2019 Messages 1,934 Location Irmo, SC Rating - 100% 9 0 0 Apr 27, 2020 #1 Ive got a Ti end cap that is 1/2-28 and I need it bored to 1 1/8"-28 to fin a silencerco nano mount.
BigWaylon Head philatelist Staff member 2A Bourbon Hound 2024 2A Bourbon Hound OG Charter Life Member Benefactor Supporting Member Multi-Factor Enabled Joined Dec 18, 2016 Messages 64,461 Location Charlotte Rating - 100% 71 0 0 Apr 27, 2020 #2 @CHRIS_WNC or @Djstorm100 ??
CHRIS_WNC Member Joined Dec 17, 2016 Messages 1,061 Location Small Town Friendly Rating - 100% 5 0 0 Apr 27, 2020 #3 I'm not set up for single point internal threading yet. I have some tooling on the way but shipping has been very slow. CHRIS
I'm not set up for single point internal threading yet. I have some tooling on the way but shipping has been very slow. CHRIS
OP wired Well-Known Member Vendor Joined Jul 9, 2019 Messages 1,934 Location Irmo, SC Rating - 100% 9 0 0 Apr 27, 2020 #4 If I were to give you an internal threading bar and inserts would you do it?
CHRIS_WNC Member Joined Dec 17, 2016 Messages 1,061 Location Small Town Friendly Rating - 100% 5 0 0 Apr 27, 2020 #5 Sure. My boring bar set should be delivered today. My inserts for my threading bar are MIA in shipping currently. I can use yours for this and send it all back when done. Send me a message and we'll get it worked out. CHRIS
Sure. My boring bar set should be delivered today. My inserts for my threading bar are MIA in shipping currently. I can use yours for this and send it all back when done. Send me a message and we'll get it worked out. CHRIS