BrewTuna Well-Known Member Joined Jan 3, 2020 Messages 560 Location GSO Rating - 100% 26 0 0 Jun 10, 2020 #1 Is there a home fix for this? I don't have any fancy tools. I also don't want to fit/buy new parts unless I have to on this gun. How much would a gunsmith charge? It's a S&W Model 66 BTW.
Is there a home fix for this? I don't have any fancy tools. I also don't want to fit/buy new parts unless I have to on this gun. How much would a gunsmith charge? It's a S&W Model 66 BTW.
Jeppo Bold inspired solutions for America 😂 Staff member 2A Bourbon Hound 2024 2A Bourbon Hound OG Benefactor Life Member Supporting Member Multi-Factor Enabled Joined May 26, 2017 Messages 34,870 Location Davidson County, NC Rating - 100% 48 0 0 Jun 10, 2020 #2 I’ll bet you can find one that’s plug and play without spending much at all.
Jeppo Bold inspired solutions for America 😂 Staff member 2A Bourbon Hound 2024 2A Bourbon Hound OG Benefactor Life Member Supporting Member Multi-Factor Enabled Joined May 26, 2017 Messages 34,870 Location Davidson County, NC Rating - 100% 48 0 0 Jun 10, 2020 #3
Frack N Cylons . Life Member Multi-Factor Enabled Joined Apr 5, 2017 Messages 7,668 Location Lincoln County Rating - 100% 26 0 0 Jul 7, 2020 #4 Not sure if it's the same one, but here is the one I got for my 686. Not worth the time or effort to go a Smith in my opinion. All I used was a thick piece of leather and good pliers. Part came from Numrich.
Not sure if it's the same one, but here is the one I got for my 686. Not worth the time or effort to go a Smith in my opinion. All I used was a thick piece of leather and good pliers. Part came from Numrich.
Frack N Cylons . Life Member Multi-Factor Enabled Joined Apr 5, 2017 Messages 7,668 Location Lincoln County Rating - 100% 26 0 0 Jul 7, 2020 #5 Be sure to turn the correct way!
Jeppo Bold inspired solutions for America 😂 Staff member 2A Bourbon Hound 2024 2A Bourbon Hound OG Benefactor Life Member Supporting Member Multi-Factor Enabled Joined May 26, 2017 Messages 34,870 Location Davidson County, NC Rating - 100% 48 0 0 Jul 7, 2020 #6 @BrewTuna How did you resolve this?
OP BrewTuna Well-Known Member Joined Jan 3, 2020 Messages 560 Location GSO Rating - 100% 26 0 0 Jul 7, 2020 #7 Ejector wasn’t bent enough to cause the hang up. Ejector rod was a tad too long. Couple strokes from a file and she runs like a top.
Ejector wasn’t bent enough to cause the hang up. Ejector rod was a tad too long. Couple strokes from a file and she runs like a top.