Finally...

88Mustang

I got nuttin
Charter Member
Benefactor
Life Member
Joined
Dec 18, 2016
Messages
1,277
Location
Clayton NC
Rating - 100%
31   0   0
I assembled my first form 1 lower
Spikes lower I SBR'ed in 2015 and a Optimus Micro that has been sitting in my safe for a year unused.

l4cjRdi.jpg


ANzVLvm.jpg


Parts list
BA modern series 12.5
Adjustable gas block
WMD NiB Bolt Carrier
Trijicon Accupoint 1-4 x 24
Gotta good deal on a SLR Hand Guard @jmccracken1214
Currently has a BFSIII which will be swapped out this afternoon for a Timney 3.5#
Upper is a YHM billet that has been used when I was doing the Ambush Action Series at Frontline Defense Range a few years ago.
I have three two day carbine classes in September - December and this thing will be put through the wringer
 
Last edited:
That's what I'll be using, the KeyMo mount. But my rail is angle slashed, it's this 556 Tactical one.
Screenshot_20190621-170340.png
Screenshot_20190621-170349.png
 

Attachments

  • Screenshot_20190621-170340.png
    Screenshot_20190621-170340.png
    284.8 KB · Views: 4
Last edited:
@JRHorne I just put the tape on it and the ALG rail is exactly 12" long from the receiver to the muzzle end of the rail. With yours being 12.37" I would say that unless the key o can go into the rail it will not fit. Mine had just about heavy 16th of an inch between rail and suppressor.
 
@JRHorne I just put the tape on it and the ALG rail is exactly 12" long from the receiver to the muzzle end of the rail. With yours being 12.37" I would say that unless the key o can go into the rail it will not fit. Mine had just about heavy 16th of an inch between rail and suppressor.
Thanks. I'll measure the rail at the top and see. I think I checked the diameter already with the KeyMo mount and it wouldn't slide into it.
 
Back
Top Bottom