Form 1 suppressor build?

Cluck Norris

Founding Inglorious bastard
Charter Member
Benefactor
Supporting Member
Joined
Dec 17, 2016
Messages
2,734
Location
I'm under your bed
Rating - 100%
52   0   0
So all my non drilled blank parts are on order to do a Form 1 suppressor. I'm trying to figure out what the proper process is on submitting all of this and I'm looking for some help. Has anybody filed one previously?
 
I might know a guy...

:p

What do you need to know? You can eFile it today and probably have an approval by Thanksgiving.

(I have six F1 cans, and a 7th that's been approved for almost three years but I haven't gotten around to making)
 
All I know is that when it was all said and done, I'd have saved money buying a commercial unit.

I did one of the SDTA Titanium builds a couple years back before they got shut down.
 
Last edited:
All I know is that when it was all said and done, I'd have saved money buying a commercial unit.

I did one of the SDTA Titanium builds a couple years back before they got shut down.
Long story short my energetic Armament Vox wasn't going to be in before the end of the year so I was cut a deal on a dead air sandman k that is in the raw. I wanted a pistol suppressor and got a stainless and titanium kit for 200.00. So I'm and going to go that route for my pcc/pistol suppressor.
 
I might know a guy...

:p

What do you need to know? You can eFile it today and probably have an approval by Thanksgiving.

(I have six F1 cans, and a 7th that's been approved for almost three years but I haven't gotten around to making)

My 45cal F1 can has been waiting about the same amount of time to be built lol.
 
I’ve been toying with building a Wolf 9SD clone of sorts but would have to sub out nearly everything.

From what I’ve seen, eforms are getting approved very quickly as of late.
 
I'd get your marking requirements taken care of first...
 
Back
Top Bottom