kriss vector SBR

amnesia

.
Staff member
2A Bourbon Hound 2024
2A Bourbon Hound OG
Charter Life Member
Benefactor
Life Member
Supporting Member
Multi-Factor Enabled
Joined
Dec 17, 2016
Messages
10,436
Location
NC
Rating - 100%
138   0   0
What stock are people running? I'm debating the folding m4 adapter but I kinda like the oem kriss vector one.
 
What stock are people running? I'm debating the folding m4 adapter but I kinda like the oem kriss vector one.

I actually like the OEM folder stock. It locks up tight and with the very minimal recoil of the V bolt it doesn’t need to be some massive contraption.

One of my favorites but dang is it expensive to shoot lol. Even with a short barrel and open sites it’s nothing to shoot rapid fire and get a 3 inch group at 40 yards and under.
 
I bought a Hera Arms Folding adapter for brace on my Vector. It takes a standard M4 threaded tube.

Do you have the 2017 version or the earlier version? The 2017 no longer has the hinge built into the frame. I ask because the pre 2017 folding stock looks awesome on the Vector. I actually contacted Kriss about buying the older upper and decided just go with the Hera Arms adapter.
 
Yep, you have the pre-2017 style. Awesome! It will make a fine SBR.

This is what a post-2017 style looks like.
F242D2DA-096E-4525-ADBE-3E5536282026.jpeg
5E890865-2357-4E83-9622-FADB4E157E47.jpeg
Notice the area behind the grip, it no longer has the hinged adapter. IMHO, your style Kriss is the better design if you are going to SBR it. With the later design you have to do work arounds like I did to just get one to fold.
 
Last edited:
Thanks all. I ordered an oem stock.

Btw my tax stamp came yesterday for it. This is the 45acp model. The mags are 40 round koren mags so the jury is still out on these till I can test.
 
I envy you, I wish I had held out and searched and bought the earlier version. I want to see it completed with the stock on it. So please keep us updated..
 
How do I attach this stock? I saw online I need to drill out the pin.
 
Looks like drilling out the pin was the way to go 5/32 drill bit and it's done.

MVIMG_20180519_082416-01.jpeg

Now I have to figure out how to get the thread protector off the barrel. It's stuck!
 
Last edited:
Back
Top Bottom