M&P 2.0 9mm

Slosolo2

Here to be happy
Joined
Dec 19, 2016
Messages
436
Location
Off the reservation (Ft. Mill, SC)
Rating - 0%
0   0   0
Anyone have experience with the 2.0 recoil springs?
I have a 4.25" model on order for my daughter to use in IDPA SSP.
She has a lot of trouble racking the slide on most guns so I would like to replace the stock spring with one a couple of pounds lighter anticipating mostly minimum power loads.

I searched youtube pretty hard for instructions on how to swap springs on the factory guide rod but didn't have much luck. ISMI says their springs fit the factory rod but don't offer any further info besides the spring rates available.

Is the 2.0 rod the same as the original M&P?
Is the retainer press fit or threaded?
Are there instructions on the web, preferably with photos, how to do this?
 
Back
Top Bottom