Silencerco Saker 556

I have a Saker 5.56 on my 10.5”. It’s the original version and I use YHM mounts. No complaints.
 
  • Like
Reactions: Tim
@Tim

Another option would be the YHM Turbo-K with an ASR module. That would cost less than the Saker, and you could also sell the YHM muzzle device, QD adapter and possibly the 1/2-28 direct thread module (if you didn’t think you’d use it) and get even more of your money back.
 
  • Like
Reactions: Tim
@Tim

Another option would be the YHM Turbo-K with an ASR module. That would cost less than the Saker, and you could also sell the YHM muzzle device, QD adapter and possibly the 1/2-28 direct thread module (if you didn’t think you’d use it) and get even more of your money back.


Their specs say minimum barrel length is 10.5” and decibel rating of 138. Doesn’t seem to stack up to the 130db (non K model) and “no restriction” of the Saker.

I may end up doing a Form 1, bit if I go commercial, I don’t mind spending the $$ for best fit.
 
Last edited:
Their specs say minimum barrel length is 10.5” and decibel rating of 138. Doesn’t seem to stack up to the 130db (non K model) and “no restriction” of the Saker.

I may end up doing a Form 1, bit if I go commercial, I don’t mind spending the $$ for best fit.
All their documentation (for every silencer I own) says 10.5”, but they say 10” is perfectly fine...not sure why they don’t just change the published info.

https://www.ar15.com/forums/Industry/Turbo-min-barrel-length-/699-291338/

(Yes, they link is for the Turbo, but it’s the first one I ran across)

It’s a K can, so it’s going to be louder than a full size. Just depends on if length/weight is your priority, or suppression level.
 
Lots of cans are starting to use the Omega style rear threads to take a plethora of mounts.

If you want to look at something like a Rex Silentium can with the ASR mount, that might be a great option for you.

Sent from my Pixel 2 using Tapatalk
 
Back
Top Bottom