McDirkale
Well-Known Member
I was having a hard time seeing my powder charges on my loadmaster. I looked at the pre-made lighting systems but they are pricey. So, I started looking and found a $8.99 sewing maching led strip light on Amazon. It came today.
Link to the light: https://www.amazon.com/dp/B088FY3CZ5/ref=cm_sw_r_cp_apa_i_zgo9EbG7CGBKK
It uses a USB style plug and everything was included. The strip is cuttable if too long...in my case it was unfortunately so I couldn't use the whole strip.
It has a cool switch that you literally just brush your finger across and it comes on. Same to turn it off.
Here it is lit up before trimming.
Here it is on the press after cleaning with alcohol and attaching, it is attached using pre-atached 3m tape.
Wow! What a difference! I can see everything in the process now and saved a substantial amount over what was pre-made. If you can't see as well as you would like, think outside the box and fix it!
Link to the light: https://www.amazon.com/dp/B088FY3CZ5/ref=cm_sw_r_cp_apa_i_zgo9EbG7CGBKK
It uses a USB style plug and everything was included. The strip is cuttable if too long...in my case it was unfortunately so I couldn't use the whole strip.
It has a cool switch that you literally just brush your finger across and it comes on. Same to turn it off.
Here it is lit up before trimming.
Here it is on the press after cleaning with alcohol and attaching, it is attached using pre-atached 3m tape.
Wow! What a difference! I can see everything in the process now and saved a substantial amount over what was pre-made. If you can't see as well as you would like, think outside the box and fix it!
Last edited:
