The other night I decided to use a neck sizing die instead of an FL die. When I went to trim them they would not fit inside the WFT. Called WFT and they said that their trimmers are set up for FL dies. This only affects 2 of the 5 trimmers, the 308 and 6.5 CM.
WFT said to send them a few neck size brass and the trimmer and they will open up the trimmer and in a few weeks I would get them back.
This got me thinking that the only time that I should need to full size a case is when I use a case that was shot in a different gun (only have 1 308 and 6.5 rifles). If I trim those cases a little bit shorter after full-length sizing them they should not stretch enough to require them to be trimmed again. AGREE?
WFT said to send them a few neck size brass and the trimmer and they will open up the trimmer and in a few weeks I would get them back.
This got me thinking that the only time that I should need to full size a case is when I use a case that was shot in a different gun (only have 1 308 and 6.5 rifles). If I trim those cases a little bit shorter after full-length sizing them they should not stretch enough to require them to be trimmed again. AGREE?