What did I do wrong, or, did I?

upnover

Well-Known Member
Joined
Jun 27, 2017
Messages
107
Location
Morganton NC
Rating - 100%
6   0   0
I have never had so much brass to clean before. Read on here better to put in a good load in the tumbler vs a light load, so, I put in a good bit. After an hour and a half, I went to look at the progress. They do not have the nice brass color to them any more, so did I put in too many? or? Or is this normal? tumbled vs not tumbled. IMG_20170628_243811690.jpg IMG_20170628_243820860.jpg
 
What media did you use?
 
OK I think I know the issue, Too many in there. Didn't realize I had put as many in there as I did. pulled out a full coffee can of them. So I am guessing too much case on case and it's basically give them a satin finish.
 
I use a 50/50 mix of corn an walnut mixture. Plus, a capful of NuFinish. Your cases look very clean, just not bright and shiny. Use them as is, or run them again with some NuFinish. And, I cut a used dryer sheet into 4 strips with each batch. The dryer sheets absorb a lot of nastiness.
 
Back
Top Bottom