Dead Air Keymo Adapter Test Fit - Charlotte Area

P

PisgahPlinker

Well-Known Member
Supporting Member
Joined
Jan 14, 2022
Messages
223
Location
Charlotte
Rating - 100%
7   0   0
I’m building a 13.7 upper with a pinned and welded Nox muzzle device (keymo compatible) and 13” handguard. I have not seen anyone use this exact handguard on a 13.7 yet, and before I pin and weld the muzzle device I want to ensure there is enough clearance to manipulate the keymo and get solid lockup on the Nox (as I intend to get a keymo can in the future).

Does anyone have a keymo equipped can around Charlotte that would be willing to let me bring my Upper by and ensure adequate fitment before I p&w? Thanks in advance!
 
I’d bet Tar Heel State Firearms does if nobody else volunteers.

If you knew you were going to buy a KeyMo adapter (as opposed to a DA can with it made into the silencer), I have plenty of cans here that you could install the adapter in and test fit if you went ahead and bought the adapter.
 
I have a Nomad-30 with KeyMo mount over in Mint Hill. I'm out a good bit this week but should be around this weekend. I'm also planning to go over to Tar Heel State Friday or next Monday to do some paperwork on a couple suppressors I ordered and purchase a Sandman if he has one.
 
Carolinatlc said:
I have a Nomad-30 with KeyMo mount over in Mint Hill. I'm out a good bit this week but should be around this weekend. I'm also planning to go over to Tar Heel State Friday or next Monday to do some paperwork on a couple suppressors I ordered and purchase a Sandman if he has one.
Click to expand...
I appreciate it and may take you up on that. I’m in no hurry and still waiting on some parts to come in so next week may work better anyway. I’ll PM you once I get my ducks in a row
 
I have a 13.7 p/w with a Nox and a sandman S, I'll try to take a picture this evening of where the suppressor sits in relation to the base of the Nox.
 
Cole_McD said:
I have a 13.7 p/w with a Nox and a sandman S, I'll try to take a picture this evening of where the suppressor sits in relation to the base of the Nox.
Click to expand...
thanks, attached is the clearance I'm working with. I basically need to know if the keymo fitting sits below the end of the nox at all!

IMG_7520.jpg
 
You should be good to go. Here is one of mine using a DA flash hider. Looks to be similar design to yours and you can see the rear shoulder sticking out of the keymo mount.

2022-10-18 13.00.35.jpg2022-10-18 13.01.09.jpg
 
Yep, looks like you got it figured out! Not that you need another pic, but here's my sandman S mounted on a Nox with a 13.7" barrel and a 12.7" rail

20221018_223051.jpg
 
You must log in or register to reply here.
Back
Top Bottom