Timney Alpha trigger pack

[BrettB]

I received a trigger kit as a gift last year - Timney Alpha it is in my Glock 19 gen 3. I seemed to have issues with light strikes and after cleaning, etc.. I figured I may have made an error on the install. I tool my gun to a Glock armorer that I trust and he verified the kit is in fact installed correctly.
I reload - I have tried CCI , Ginex and Winchester primers - I kept blaming my reloads so for the past few months I’ve been buying 9mm factory loads and still getting light strikes. Primer will be faintly dimpled but not enough to ignite
Has anyone had this issue and what is the fix

 

[Freedom777]

Striker could be dragging on top of trigger bar where it contacts with housing. Look at the small valley on top of trigger bar and see if the striker is making contact with it. It will have marks if it is. I've seen this before. Some say to Dremel that little valley on the trigger bar a little deeper. I never had a problem with mine. I think there are several YT videos about it.

 

[BrettB]

Thanks I’ll check out YT for videos.