@BatteryOaksBilly
Finally got my Lyman back from my friend and did the install of the Overwatch Precision Falx trigger and 3.5# Ghost connector on my G48.
Prior to install:
Takeup measured approx 3/16" as best I could do it.
When you hit the wall, there was maybe 1/16" creep before the break.
There was no discernable overtravel.
Tested five trigger pulls for an average of 5 lbs 13 oz. However, they were not consistant at all. Low pull at 4 lbs 13 oz and high pull at 6 lbs 4 oz.
Forget to check reset length. My bad.
After install:
Takeup remained the same at approx 3/16".
The wall was less defined, but there was approx 1/8" creep before the break.
Overtravel stayed the same at next to nothing.
Tested five trigger pulls for an average of 4 lbs 11 oz. Lost a little over a pound, but the biggest thing was the consistancy. Low pull at 4 lbs 10 oz and high pull at 4 lbs 12 oz. Far more consistant than stock.
Reset length approx 3/16" with the same 1/8 in creep before break.
The feel of the trigger face is vastly improved
Recap:
Lost wall resistance
Increased creep minimally
Dropped over a pound on the pull
Far more consistant
Feel 1000% better
Imho, the good things that came out of it far outweigh the slight degradition of the wall and creep.
All that's left is to make it go bang a few times lol