WOT Wide Open Trigger on Big Daddy Unlimited

[Bigdave0924]

Update:

The designer explained that the slop was necessary because without it, the trigger components were being beat to hell.

To my friend's specific problem, it was determined he was keeping too much pressure on the trigger. He admitted to keeping that pressure on it, thinking it was necessary to take up play.

With that info, he went back out and tried it again with less pressure and said it works like it should.

I can verify if you put too much pressure on the trigger it will not work as designed. The first couple times I shot mine I was using too much pressure on the trigger pull and the result was a dead trigger.

If the trigger group needs to bounce around, then is there extra wear on the lower that needs to be watched for?

I doubt it’s anything to worry about. What in the lower could wear to the point that it would be an issue?

 

[CarolinaColtCollector]

I doubt it’s anything to worry about. What in the lower could wear to the point that it would be an issue?

If you wallow the trigger pin holes out enough you can mess with the geometry of a standard trigger or have pins walk out. I know *most* triggers hold the pins in place with the hammer spring… but chit happens.