I reloaded 8 of the 1.140 over all length dummy rounds this morning, loaded up a Glock mag and manually cycled the G19, no issues at all, they feed and eject as they should so I'll load about 10 live rounds using 3.9/4.0 grains of titegroup and hopefully have time to go test firm next weekend.
Results in the AR9 were a failure. Manually cycling letting the bolt freely fall forward, I was not able to pull the bolt back and had to use a wooded dowel and tap the round out of the chamber. I am guessing this means I may have gotten one of PSA's guns with the tight chamber, is there something else I should be looking at as a cause?I've only fired the AR9 once a few weeks ago and then had one failure where the spent round ended up not ejecting from the gun and landed just above the hammer. Is there a thread someone can point me to about the chamber issue with PSA's AR9's?
Results in the AR9 were a failure. Manually cycling letting the bolt freely fall forward, I was not able to pull the bolt back and had to use a wooded dowel and tap the round out of the chamber. I am guessing this means I may have gotten one of PSA's guns with the tight chamber, is there something else I should be looking at as a cause?I've only fired the AR9 once a few weeks ago and then had one failure where the spent round ended up not ejecting from the gun and landed just above the hammer. Is there a thread someone can point me to about the chamber issue with PSA's AR9's?